Step 1.
Push button in with thumb or finger until lock lever is released.
Push button in with thumb or finger until lock lever is released.
Step 2.
Lift open lock lever. After opening lock lever make sure the spring catch has snapped back into it's hole push it back into place if necessary with your finger.
Lift open lock lever. After opening lock lever make sure the spring catch has snapped back into it's hole push it back into place if necessary with your finger.
Step 3.
Feed strap end through bottom of buckle.
Feed strap end through bottom of buckle.
Step 4.
Feed strap end out the front of the buckle.
Feed strap end out the front of the buckle.
Step 5.
Pull out slack (DON'T TIGHTEN YET)
Pull out slack (DON'T TIGHTEN YET)
Step 6.
Push down on lock lever to close . If lever is hard to close. Simultaneously pull with your fingers and push down lever. Or open lever loosen strap a little and reclose. Its always closes easier by pushing the cam forward with your finger while closeing.
(TIP - It also closes easier by pushing the cam forward with your finger while closeing)
Push down on lock lever to close . If lever is hard to close. Simultaneously pull with your fingers and push down lever. Or open lever loosen strap a little and reclose. Its always closes easier by pushing the cam forward with your finger while closeing.
(TIP - It also closes easier by pushing the cam forward with your finger while closeing)
Step 7.
MAKE SURE LEVER CATCH IS FULLY ENGAGED! CATCH BUTTON MUST PROTRUDE OUTSIDE OF BUCKLE APPROX. (1/8' INCH) PULL UP ON THE LEVER TO TEST IT. IF YOU ARE NOT SURE USE THE LOCK.
MAKE SURE LEVER CATCH IS FULLY ENGAGED! CATCH BUTTON MUST PROTRUDE OUTSIDE OF BUCKLE APPROX. (1/8' INCH) PULL UP ON THE LEVER TO TEST IT. IF YOU ARE NOT SURE USE THE LOCK.
Step 8.
Pull strap to tighten
Pull strap to tighten
DOWNLOAD STEELCORE SECURITY STRAPS INFORMATION GUIDE
steelcore_info.pdf 824kb